Rose electronics UltraLink 2 Manual de instrucciones descargar pdf (Pagina 14)

8 UltraLink 2 DVI Installation and Operation Manual

Figure 5. Network connection

For Ethernet Connection to the UL2-DVI

 Connect the port labelled Link on unit to the Local Area Network or internet using a CATx cable.

Optional Connections

The UL2-DVI has two optional connections: to input audio from the host computer or KVM Switch, and to

provide a means to serially control a remote power switch. These connections are shown below.

Figure 6. Optional Serial and Audio connections

For Audio Input to the UL2-DVI

 Connecting to a host computer: Use the supplied 3.5 mm stereo jack cable to connect the audio jack

labeled In Audio to the audio output connector on the host computer.

 Connecting to a KVM switch: Use the supplied 3.5 mm stereo jack cable to connect the audio jack labeled

In Audio to the audio output connector on the User Console of the switch.

Note: Audio support through the UL2-DVI is only provided by the RealVNC Viewer that is included in the unit.

Later Viewers downloaded from the RealVNC website do not provide audio support.

For Serial Connection to a Remote Power Switch

 To control a remote power switch from the unit, connect the supplied serial power control cable between

the RS232 connector labeled Serial and the RJ-45 serial connector on the remote power switch.

Connections based on DIP Switch 1

The UL2-DVI can draw power from either two USB connections to the host computer or KVM Switch, or from

the optional AC power adapter. The position of DIP Switch 1 determines the source of its power.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Sin comentarios

Rose electronics UltraLink 2 Manual de instrucciones Pagina 14