Rose electronics UC2-1x16U/E Manual de instrucciones descargar pdf (Pagina 56)

50 ULTRACONSOLE INSTALLATION AND OPERATIONS MANUAL

Appendix G. Password jumper

If the configuration password is ever forgotten, the UltraConsole switch has a special “Password” reset jumper on the

CPU card. This jumper is labeled JP31 on all models. To use this jumper to bypass the password, perform the

following:

1. Turn off the UltraConsole switch and remove the top cover.

2. Install a jumper on JP31 to short the two terminals.

The login requirement will be bypassed and you will be granted access. This does not delete the password, only

bypasses the function.

3. Power on the UltraConsole with the jumper in place.

4. Call up the main menu; select “System” and press [Enter].

5. Select “Configure password” from the configure system menu and press [Enter].

6. Enter a new configuration password and press [Enter].

7. Save the new configuration password from the “Main Menu”.

8. With the new password saved, turn off the UltraConsole switch.

9. Remove the jumper on JP31.

10. Re-install the top cover.

11. Turn the UltraConsole on. The UltraConsole switch will boot up and the new password will be effective.

Appendix H. Diagnostic check / error messages

The power on diagnostic screen that appears when the UltraConsole switch is first turned on, checks the switch and

provides the information shown on the screen.

Welcome to UltraConsole

Power on diagnostics

Kernel version KX20

Overlay version 051R

Kernel program Good

Static ram Good

Hardware type MP2X8E

Configuration Good

Board number 1

Communication ID 1

Communication Good

Local CPU ports 8

Program version MX22D

Main program Good

PC keyboard detected

PS2 mouse detected

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62

Sin comentarios

Rose electronics UC2-1x16U/E Manual de instrucciones Pagina 56